Air Duster & Nozzle Organizer – Compatible with WOLFBOX MF100

## WOLFBOX MF100-Compatible Air Duster Organizer

A compact desktop storage stand designed to hold a WOLFBOX MF100 electric air duster together with all four nozzle attachments supplied with the unit.

I designed this because I wanted the air duster and its attachments stored together, upright and ready to use, rather than having the smaller nozzles loose in a drawer.

## Features

- Holds one WOLFBOX MF100 electric air duster

- Dedicated storage for all four included attachments

- Keeps the complete set together in one compact organiser

- Flat, stable base for desktop, shelf or workshop storage

- Open design makes each attachment easy to identify and remove

- Printed as a single piece

- No assembly or additional hardware required

## Compatibility

Designed and test-fitted using the WOLFBOX MF100 electric air duster and the four attachments supplied with my unit.

Manufacturing tolerances or accessory bundles may vary between regions or later product revisions. Please compare the model dimensions with your own device before printing if your attachment set appears different.

This model has not been tested with the WOLFBOX MF50, MF60, MF200 or other air-duster models.

## Recommended print orientation

Print the organiser upright, with the large flat bottom surface placed directly on the build plate.

The uploaded model is already oriented for printing.

## Suggested print settings

- Material: PLA or PETG

- Layer height: 0.20 mm

- Walls/perimeters: 3

- Top layers: 4

- Bottom layers: 4

- Infill: 10–15%

- Infill pattern: Gyroid or Grid

- Supports: Not required

- Brim: Usually not required

- Nozzle: 0.4 mm

PLA is suitable for normal indoor desk or workshop use. PETG may be preferable if the organiser will be kept in a hot garage, vehicle or other warmer location.

The model does not require especially high infill because most of its strength comes from the outer walls.

## Fit notes

The holders are intended to keep the attachments upright without requiring excessive force.

Fit can vary slightly depending on your printer calibration, material and extrusion settings. If the holes print too tightly, check your flow calibration or apply a small amount of XY/hole compensation in your slicer.

## Files included

- Printable 3MF model

- Single-piece organiser for the air duster and four attachments

## Independent accessory disclaimer

WOLFBOX and MF100 are trade marks or product identifiers belonging to their respective owner.

This is an independently designed, unofficial accessory. It is not manufactured, endorsed, sponsored or supplied by WOLFBOX. The WOLFBOX name is used only to identify the product with which this organizer was designed to be compatible.

The electric air duster and nozzle attachments shown in the photographs are not included.