Modular Drill Press Caddy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modular drill press caddy with interchangeable adaptors to mix and match and desired.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This modular drill press caddy was designed for a 48mm thick column. It was designed around a Ryobi benchtop drill press.
I have added bracket diameters from 50-80mm in 5mm increments. Each "half" bracket has 3mm removed i.e. you should have 6mm gap between two haves if you use a size that is exactly the same size as your column. This means you should be able to use e.g. a 65mm bracket on a 63mm column diameter.
Print any resolution and fill for extenders. You will need to reorientate some of the models and print support where needed.
Use tree supports to reduce residual material on connectors. File down connectors if needed.
Print swivels at a finer resolution (<0.16mm). Orientate the swivel so that it would swivel vertically on the print bed. No supports will be needed. You may need to break the connector lose after it has printed.
Increase wall thickness (wall loops) for strength.
The bracket holes are 6mm in diameter. I used 30mm bolts to secure the bracket. Avoid over tightening so you can swivel the caddy out the way if necessary.
The round magnetic tray can be found in the link below:
The drill bit box was remixed from the following model: