TP-Link Archer AX12 Ventilated Tape-On Wall Mount

Ventilated, bucket-style wall cradle designed specifically for the TP-Link Archer AX12 (AX1500 Wi-Fi speed class).

IMPORTANT COMPATIBILITY

This model fits the Archer AX12 body envelope: 215 × 117 × 32 mm. TP-Link also sells a different, larger product named Archer AX1500 (260.2 × 135 × 38.6 mm); that model will not fit. Check the underside label before printing.

FEATURES

• One-piece support-free cradle

• Ports and four antennas remain fully accessible at the top

• Low center lip keeps the status LEDs visible

• 8 mm rear ventilation gap with large back and shelf openings

• Four solid rear zones for high-bond double-sided tape

• Slots for an optional 16 mm Velcro retention strap

• Parametric OpenSCAD source included

• Small depth gauge and full-width fit strip included

PRINT THE FIT TESTS FIRST

Print AX12_Depth_Fit_Gauge.stl using the final material and profile. If it slides over the thickest point of the router without force, print AX12_Full_Width_Fit_Strip.stl to verify width and depth before committing to the complete holder.

PRINT SETTINGS

Material: PETG recommended; ASA for warm or sunlit locations

Layer height: 0.20–0.28 mm

Walls: 4–5

Top/bottom layers: 5–6

Infill: 25–35% gyroid or cubic

Supports: Off

Brim: 6–8 mm recommended

Orientation: Bottom shelf flat on the build plate

The holder measures 228 × 50 × 82 mm. Rotate it approximately 45° to fit a 220 × 220 mm bed.

TAPE INSTALLATION

Use genuine high-bond acrylic-foam mounting tape rated for at least three times the combined router and cradle weight. Apply one strip across the solid top band, one across the bottom, and one vertical strip at each outer side, as shown in AX12_Tape_Layout.png. Keep all ventilation openings clear.

Use only on a smooth, sound, sealed surface. Do not use ordinary stationery/carpet tape or attach it to dusty brick, rough plaster, wallpaper, damp surfaces, or loose paint. Prepare surfaces and observe the manufacturer’s full cure time—often 24–72 hours—before loading.

Install the router with the ports and antenna hinges at the top. Leave at least 170 mm of free space above the body plus cable-bend clearance.

SAFETY

Adhesive strength is limited by the wall finish: strong tape can still detach with the paint layer. Test with a padded dummy load, inspect for peeling or creep, and do not mount over a bed, chair, or valuable equipment until physically verified. Digital mesh validation does not prove adhesive strength, real-world fit, cooling, or long-term material behavior.

VALIDATION

All included STLs passed single-component, watertightness, consistent winding, positive-volume, boundary-edge, non-manifold-edge, degenerate-face, and expected-dimension checks. The nominal 215 × 117 × 32 mm router envelope produced 0.0 mm³ digital interference at the designed clearances.

Independent compatibility design; no TP-Link branding is reproduced.