Simple riser for Elegoo centauri carbon 1 with canvas - Remix with minor tweaks

Prints without supports.

I ordered the following acrylic panels for mine, the model can accept up to 4mm deep panels, but I went with 3mm as it was more readily available:

Dark tinted 3mm panels from cutmy.co.uk for approx £25 delivered -

2x 3mm x 240mm x 310mm
1x 3mm x 324mm x 240mm
2x 3mm x 241mm x 73mm


Slight remix of the excellent model by Jo Larsen, this slightly adjusts a couple of the dovetails to make them a little more snug and lengthens the top bars as I found that the original print couldn't accomodate the glass top - this may well have been my printer calibration but maybe it'll help others with the same issue.

The only changed parts are the 4 top bars, if you've already printed Jo's you only need to do these 4 pieces.  Also note in my model the thin / thicker bars are identical each side whereas in Jo's model the thicker ones are slightly different to each other.

Note, I could have increased the size of the holes on the verticals as they were very tight fit on mine, but I just reamed mine out a little with a 5.5mm drill bit so didn't feel the need, again printer tolerance will likely come to play here.