Simple riser for Elegoo centauri carbon 1 with canvas - Remix with minor tweaks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minor remix of Jo Larsens excellent riser for the Elegoo Centauri Carbon 1 to allow use of the canvas system
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 87
- Makes
- 1
- Views
- 602
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Prints without supports.
I ordered the following acrylic panels for mine, the model can accept up to 4mm deep panels, but I went with 3mm as it was more readily available:
Dark tinted 3mm panels from cutmy.co.uk for approx £25 delivered -
2x 3mm x 240mm x 310mm
1x 3mm x 324mm x 240mm
2x 3mm x 241mm x 73mm
Slight remix of the excellent model by Jo Larsen, this slightly adjusts a couple of the dovetails to make them a little more snug and lengthens the top bars as I found that the original print couldn't accomodate the glass top - this may well have been my printer calibration but maybe it'll help others with the same issue.
The only changed parts are the 4 top bars, if you've already printed Jo's you only need to do these 4 pieces. Also note in my model the thin / thicker bars are identical each side whereas in Jo's model the thicker ones are slightly different to each other.
Note, I could have increased the size of the holes on the verticals as they were very tight fit on mine, but I just reamed mine out a little with a 5.5mm drill bit so didn't feel the need, again printer tolerance will likely come to play here.