Micro SD & SD Card Case watertight screw on
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
8 Micro SD Cards and 5 SD Cards in a good watertight seal (not guranteed) you can use a O-Ring to improve the seal
- Ocena
- 4,75 / 5
- Polubienia
- 162
- Pobrania
- 482
- Wydruki
- 5
- Wyświetlenia
- 1716
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A good SD Card Enclosure to carry more SD Cards safely is a must have, for every filming or Photo shooting seshion, which i have created this model for.
The key to the water resistant seal is screwing it on real hard best with an O-Ring.
There are 2 Versions, one with a tight fit on the Micro SD's, and another witch a looser fit, both of them can be used with the top part. 5 SD Cards can take place and 8 Micro SD Cards can be put in. The Hexagon pattern is put on with Bump Mesh by CNC Kitchen (not sponsored & free to use). I have put a groove in the model right under the thread, a 35mm x 2mm O-Ring will fit. It will improove the watertightness, eventhough it isn't guaranteed, that it is watertight, but my tests have shown it has a good seal, even without the O-Ring. The two parts should be printed seperatly and the thread may take a few turns to get worn in nicely.