Flight ramp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Works for hive gates that are 135 mm. (AI picture is not totally accurate).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 295
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model helps bees by having a nice platform for them to land on or take off from. It's efficient because you do not have to remove it to spin the gate and it can also kind of work for the u-shaped opening.
If you print one of the ramps for a P-Hive you will need supports.
To put this on you just need to unscrew the gate line up the screw hole in front and rescrew the screw back in.
The difference between the P-Hive models and the generic models is that the P-Hive has a little bump out where the screw is which then makes it so the piece that has to be screwed has to be off the ground so it lines up thus making it need supports.
The models with the L have a 4.5mm screw hole and the models with the S have a 3.5mm screw hole
Tell me if you would like 3mf files.