Apollo MSR-2 tilted corner wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A corner wall mount for the Apollo Automations MSR-2 mmWave presence sensor, with 30º downwards tilt
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An external housing to wall-mount the Apollo Automations MSR-2 mmWave presence sensor in a corner, with 30º downwards tilt. This align with the vendor's recommendation to fix at 1.5-2m height. I filleted the back to allow for a bit of corner tolerance, and mounted with command strips.
I printed mine with PLA+ at 0.2 layer height with organic supports. It's a small part, so bed adhesion is tricky. I had best success adding a decent amount of brim (7mm) and similar first layer expansion for the supports, and printing the rectangular front face flat-to-bed (so the rounded corner piece was pointing up). Thanks @earu for the source model.