1 / 2
Easy-Measure Kitchen Scoop — zdjęcie 1
1 / 2

Easy-Measure Kitchen Scoop

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

4,45 € – 5,44 € netto (bez VAT)

Dla pliku: scoop_0.4n_0.15mm_PLA_MK4S_4h16m.bgcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 4,95 € netto (środek widełek).

Masa podana przez autora
76 g
Czas druku podany przez autora
4,27 godz.
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Easy Measure Adjustable Kitchen Scoop, with 2 Separate Stops to let you measure out 1 Cup, 3/4 Cup, 1/2 Cup and 1/4 Cup.

Ocena
0 / 5
Polubienia
5
Pobrania
10
Wydruki
0
Wyświetlenia
71
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

PLEASE MAKE SURE TO PRINT WITH FOOD-SAFE PLA OR BAMBU LAB PLA PURE!

This Model is designed to come in direct contact with food. Please make sure to print in Food-Safe PLA or Bambu Lab PLA Pure. Make sure to wash before use, and Wash well after use.

This model is specially designed and oriented to be as food safe as possible.

It is True that PLA PURE and many Food safe PLAs are certified to be food safe. but the final prints often arent, because they feature small details that break off, stringy bridges that turn into microplastics, and crevices where food gets stuck and rots. This model is designed to overcome those issues.

The layer height is 0.16 so the tiny crevices between the layer are smaller, and dont let larger particles like sugar or oats in at all. I Removed and bridges and supports from the parts that touch the food. I went thru mant variations and versions to get this one which doesent bridge inside the scoop, and only uses supports for a small section of the outside. that section is flattened to make support removal easier, leaving no interface parts, meaning less microplastic. There is almost no point where microplastic could leave the model and enter food in this model. The whole model is printed with long even layer lines, with no small details which could break off. The whole inner shell is rounded, so there are no crevices where food gets stuck.

Print Settings:

Orient on the back

0.16 Layer Height

Seam Position: Back

Top Shell Layers: 4

Bottom Shell Layers: 4

Perimeters: 2

Infill: 15%

Supports: Tree Slim(Auto) or Everywhere in Prusaslicer

Tagi