Easy-Measure Kitchen Scoop
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.45 – €5.44 net (excluding VAT)
For file: scoop_0.4n_0.15mm_PLA_MK4S_4h16m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.95 excluding VAT (range midpoint).
- Weight reported by the author
- 76 g
- Print time reported by the author
- 4.27 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Easy Measure Adjustable Kitchen Scoop, with 2 Separate Stops to let you measure out 1 Cup, 3/4 Cup, 1/2 Cup and 1/4 Cup.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 10
- Makes
- 0
- Views
- 71
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
PLEASE MAKE SURE TO PRINT WITH FOOD-SAFE PLA OR BAMBU LAB PLA PURE!
This Model is designed to come in direct contact with food. Please make sure to print in Food-Safe PLA or Bambu Lab PLA Pure. Make sure to wash before use, and Wash well after use.
This model is specially designed and oriented to be as food safe as possible.
It is True that PLA PURE and many Food safe PLAs are certified to be food safe. but the final prints often arent, because they feature small details that break off, stringy bridges that turn into microplastics, and crevices where food gets stuck and rots. This model is designed to overcome those issues.
The layer height is 0.16 so the tiny crevices between the layer are smaller, and dont let larger particles like sugar or oats in at all. I Removed and bridges and supports from the parts that touch the food. I went thru mant variations and versions to get this one which doesent bridge inside the scoop, and only uses supports for a small section of the outside. that section is flattened to make support removal easier, leaving no interface parts, meaning less microplastic. There is almost no point where microplastic could leave the model and enter food in this model. The whole model is printed with long even layer lines, with no small details which could break off. The whole inner shell is rounded, so there are no crevices where food gets stuck.
Print Settings:
Orient on the back
0.16 Layer Height
Seam Position: Back
Top Shell Layers: 4
Bottom Shell Layers: 4
Perimeters: 2
Infill: 15%
Supports: Tree Slim(Auto) or Everywhere in Prusaslicer