1 / 3
XShot MPP "Talus" Dual Talon Mag Holder — zdjęcie 1
1 / 3

XShot MPP "Talus" Dual Talon Mag Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dual Talon Mag Holder custom built for the MPP

Ocena
0 / 5
Polubienia
8
Pobrania
19
Wydruki
0
Wyświetlenia
124
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Run out of mag pouches but still need to carry more mags? The Talus provides two quick access mags held securely on the sides of the blaster. Designed for right hand users, the asymmetrical mag releases allows for intuitive thumb pulls of the mags with the left hand on both sides to insert into the magwell of the MPP without any contorting. Will fit multiple short dart mag types, including Talons, XShot, and Adventure Force/Katana (requires a cut in the mag to use the talon mag catch location). 

Hardware Requirements:
4x 1/8"x1" round pins

Build Instructions:

For best results and the least post processing for fitting, print with a horizontal offset of -0.1mm. 

Insert the mag release into the slot until the hole lines up with the rearmost hole, then put a pin through it. Then insert the front pin which acts as an overtravel stop for the mag release. Cover the pin holes with some tape to secure it in place, or burr the ends of the pin prior to insertion. Gluing the pins in place is not recommended as the mag release spring may wear out over time and need replacing. Once assembled, unscrew the buffer tube from the MPP and insert the mag holder in place. Screw the buffer tube back down, and use the castle nut to securely tighten everything in place.

Tagi