1/10 Log Bunk for 4X3D Tatra Force
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Log bunk for 4X3D 1/10 Tatra Force. For both 4x4 and 6x6 versions.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 168
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1/10 Log bunk for 4X3D Tatra Force. Will fit both 4x4 and 6x6 version. 6x6 can have a total of ten bunks compared to the six of the 4x4 although I feel like having six looks best on both versions. The log bunks and cab protection are 280mm wide so you’ll need a print bed at least that big.
Hardware needed; 26 M3X30, 4 M3X16
For six bunks you’ll need to print: 1x log bunk cab, 3x log bunk support, 1x log bunk no support and 1x log bunk back. Log bunk no support goes 3rd space from the front as the supported version does not fit over the bracket.
To get the mesh on the cab protection you will need to load the respective modifiers for each part. For the main cab protection I used a 25% rectilinear infill with top and bottom layers set to zero, for cab protection base use same settings but a 20% infill. Once sliced it should end up looking like this
12x M3x30 for attaching bunks to bed
4x M3x16 for attaching rear bunk
14x m3x30 for cab protection side brace & base
