Alternate Cover for Prusa MK3/S Einsy Raspberry PI 4B/3B Enclosure with support Brace
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New Cover for KalleKnalls orginal enclosurer using the honeycomb design from Aamers cover, use with KalleKnalls orginal
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a slightly different look for my cover piece, so designed this 3 piece cover using the blank cover from KalleKnalls design and the Honeycomb from Aamers design.
Mines printed in black PETG and white ABS-GF, the parts should be a very tight fit (50um clearance all round) however as there can be cable pressure pushing them out recommend these are glued in using a 5 min epoxy glue, I don't recommend superglue as it can "frost" parts.
If the parts end up to tight just run a steel ruler down the sides of the grills and it should take enough off to allow them to fit in.