Alternate Cover for Prusa MK3/S Einsy Raspberry PI 4B/3B Enclosure with support Brace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
New Cover for KalleKnalls orginal enclosurer using the honeycomb design from Aamers cover, use with KalleKnalls orginal
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I wanted a slightly different look for my cover piece, so designed this 3 piece cover using the blank cover from KalleKnalls design and the Honeycomb from Aamers design.
Mines printed in black PETG and white ABS-GF, the parts should be a very tight fit (50um clearance all round) however as there can be cable pressure pushing them out recommend these are glued in using a 5 min epoxy glue, I don't recommend superglue as it can "frost" parts.
If the parts end up to tight just run a steel ruler down the sides of the grills and it should take enough off to allow them to fit in.