Custom Electronics Enclosure Prototype for Reused Vape Components
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An unfinished enclosure concept for reusing electronics, battery contacts and a connector assembly from an old device
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Custom Electronics Enclosure Prototype for Reused Vape Components
An unfinished enclosure concept for reusing electronics, battery contacts and a connector assembly from an old vape device.
Need a custom part for your setup? I design print-ready models from photos, sketches and measurements. Request a custom design
I started this as an experiment in reusing working electronics from a damaged device instead of replacing the whole unit. The enclosure was designed around the existing board, display, battery contacts and upper connector, but the project was never fully finished.
Key details
Height: 85 mm
Width: 26.5 mm
Length: 33 mm
Files included
Prototype electronics enclosure model
Important
This is an unfinished prototype, not a validated product. Battery-powered and heating electronics can present fire, burn and electrical risks. Verify every component, clearance and connection before use.
Follow me: roqd.one
roqd/m31