Rubber band gun / launcher that actually works
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rubber band gun for up to four bands. Tool-free assembly (rivet-free version) or with filament-pieces as rivets.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
Rubber Band Gun / Launcher toy that actually works!
Easy-to-print, reliable rubber band launcher, can load up to 4 rubber bands. Great toy! Two versions: with rivets (small filament pieces are used as rivets, looks pretty) and without rivets. Rivet-free version assembles without tools.
Advantages:
Cool toy :D
nicely small
Fits four rubber bands
super easy to print
launches rubber band at trigger pull (not trigger release like some other models)
very reliable
Kids-friendly, easy reloading
Printing:
All five pieces should be printed with 0.2mm layer height and without brim. The tip of the gun has a brim included by itself (0.2mm thick circle) to prevent the horns from lifting up. That brim can be removed easily at the end.
There are two versions: With and without rivets. Both versions are assembled in the same way, see pictures. The toothed wheel and the trigger are a slide fit on their pegs (if not: some sand paper helps) and the studs/holes to attach the lid are a push fit.
Assembly: See pictures.
Rivet-Version:
To make a rivet, take a piece of filament, heat the tip with a lighter and squeeze it against an edge to create the rivet head. Cut the rivet off at a half inch. Heat the other end and squeeze it round with your fingers to create a narrow tip that fits through the hole. Push rivet through hole, cut it off and leave 1/16'' poking out. Carefully reheat tip with lighter and squeeze flat with a screwdriver.