1 / 2
Nordica 16 Sailboat Tiller Mount — zdjęcie 1
1 / 2

Nordica 16 Sailboat Tiller Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement for the wood bits atop the 1" wide rudder that form a socket for the tiller handle.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Share Alike

The wooden tiller handle mount on the rudder was getting soft where years of wear wore away the varnish.  (Try saying that 3 times fast).  Purists may be upset, but I decided on a 3D printed version. I traced out the original on graph paper for precise reproduction in CAD. I prototyped this in PLA but strongly recommend at least PETG or preferably ASA for longevity. 

The 5 mounting holes are sized to recess M6 x 55mm stainless steel socket cap screws on one side and M6 x 12mm brass heatset inserts on the other. The hole positions are located where MY mounting screws were found -- but photo's I've seen of other Nordica's only show 4 bolts, so yours may differ. Parametric Freecad file included for customization. 

Obviously this needs to be strong. You don't want the tiller breaking it off while fighting a strong wind. Print laying flat with full support. I found Orca's "snug" setting peeled out of the pockets very nicely. Lots of walls, tops and bottoms. I used 6 of each with 40% gyroid infill. 

Tagi