Neptune 4 plus - Chute adaptor for fan air extraction
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chute air extraction for Neptune 4 plus. You need to attach a fan connected to a tube so the air is extracted out.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this chute to extract air while printing. It works quite well up to model tall 20 centimetres more or less. More than that and the air probably is sent out of the chute's reach. I might add an extension later, but for now is not something I really need.
I used the following filament, and I recommend not using PLA as with heat it might loose some strength overtime. I didn't test it, is just a guess.
PETG LITE from THE FILAMENT by spectrum. 220-250 temp
Nozzle 0.4
Avg Temp: 240 (250 might be better for overhangs)
wall at around 0.6 works good.
you need some screws to tighten it up.
I added a central reinforcement that should handle heavier loads, however don't push it too much or if you do, plan accordingly.
100% human-made. No AI used.