1 / 3
Speedometer housing for Campers and Cars — zdjęcie 1
1 / 3

Speedometer housing for Campers and Cars

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a housing for a GPS driven Speedometer.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Open Community License v1.1

Housing for a Speedometer based on CYD (Cheap Yellow Display) with GPS and light sensor.

The code (Arduino) and further description can be found on GitHub: 
https://github.com/Martinus117/Speedometer_CYD

I prented the housing with PC Blend to give it a better temperature stability (it can get really hot in cars under the windshield).

PC Blend is a bit difficult to print, so you might need to experience. I think PETG also works.

I used 0.2mm layer height with no support. The small GPS Holder should be printed face down.

The lid is prepared for heat-set threaded inserts M3, h=6mm