Paramotor Throttle with cruise control. Dual start version. By Twisted Risers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Twisted Risers throttle dual start version. After lots of requests for a dual start version here it is. Two finger…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 419
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Twisted Risers throttle dual start version.
After lots of requests for a dual start version here it is.
Two finger throttle for paramotor. You will require:
2 off 7mm OD 4mm ID bearings for the lever https://www.amazon.co.uk/sourcing-map-MR74-2RS-Groove-Bearings/dp/B082PS4RVW/ref=sr_1_2?keywords=7mm+od+4mm+id+bearing&qid=1581350946&s=diy&sr=1-2
2 off 12mm SPST buttons for start and engine kill switch suggest red and green. https://www.amazon.co.uk/sourcingmap-Black-Momentary-Button-Switch/dp/B07FRYDCZ5/ref=sr_1_21?crid=OM750YN1ROZW&keywords=12mm+SPST+button&qid=1647092357&sprefix=12mm+spst+button%2Caps%2C70&sr=8-21
Screws / washers etc. If you fly paramotors you will figure it out.
Use your exsisting cables or buy new.
Para-Norman PPG did a great video on it here:
If you do not have a 3d printer can i suggest you contact Kyle Davies at the links below. He can print the parts for you with a percentage of the cost going to UK Alzheimers charity.
Website
Para-Normalppg.com
Facebook https://www.facebook.com/ParaNormalPPG
Ebay https://ebay.co.uk/usr/para-normalppg
Print Settings
Printer Brand:
TEVO
Printer:
Tornado
Rafts:
No
Supports:
Yes
Resolution:
.28
Infill:
70%
Filament: 3D-Printz PETG black
Notes:
You can print this with PLA but please be aware PLA is broken down by UV in the sunlight and will turn brittle.
Category: Sport & Outdoors