1 / 1
Palette 3/3Pro Inlet PTFE Tube Tensioner — zdjęcie 1

Palette 3/3Pro Inlet PTFE Tube Tensioner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This fixes the issue where filament can sometimes back itself out of the Palette 3.

Ocena
5 / 5
Polubienia
10
Pobrania
124
Wydruki
3
Wyświetlenia
792
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This bracket was originally designed by audiorazor, and allows for the installation of PTFE tubing into the Palette 3, and 3 Pro.

I personally was having problems with my filaments pulling themselves out of the Palette just because of the filament's natural springiness.  So, I took audiorazor's design and added some holes that allows for the installation of 3mm screws.  The screws can then be tightened to allow just a little bit of friction to the filament so that will not pull itself out.  

When tightening the screws just screw them in enough to apply a small amount of tension to the filament.  If you over tighten the screws the filament is just going to get chewed up by the selector shaft, and you will most likely get a failed print.

Tagi