1 / 1
Palette 3/3Pro Inlet PTFE Tube Tensioner — image 1

Palette 3/3Pro Inlet PTFE Tube Tensioner

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This fixes the issue where filament can sometimes back itself out of the Palette 3.

Rating
5 / 5
Likes
10
Downloads
124
Makes
3
Views
792
Reviews
3

Updated at source:

Model information

License
Creative Commons — Public Domain

This bracket was originally designed by audiorazor, and allows for the installation of PTFE tubing into the Palette 3, and 3 Pro.

I personally was having problems with my filaments pulling themselves out of the Palette just because of the filament's natural springiness.  So, I took audiorazor's design and added some holes that allows for the installation of 3mm screws.  The screws can then be tightened to allow just a little bit of friction to the filament so that will not pull itself out.  

When tightening the screws just screw them in enough to apply a small amount of tension to the filament.  If you over tighten the screws the filament is just going to get chewed up by the selector shaft, and you will most likely get a failed print.

Tags