Magnetic external prime bucket for C1 INDX - Vase & Standard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recreated external prime bucket to use without assistance of right side spoolholders
- Ocena
- 4,417 / 5
- Polubienia
- 91
- Pobrania
- 274
- Wydruki
- 13
- Wyświetlenia
- 1551
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Open Community License v1.1
Original external prime bucket is made to be held in place by spoolholders. These prints ads magnets to snap to the right side panel.
This version is NOT Prusa original extended bucket but with magnet. It have different dimensions, as I couldn't line original in CAD without clipping into side panel. It is created from scratch, with inspiration of the original extended bucket.
Made for 20x6x2 magnets and a bit of glue (slightly oversized holes)
Confirmed working:
Angle correction plate - TESTED
Basically just to make level plane for the bucket to sit on
5x holes for magnets, choose how many you'd like to insert, use of glue required (magnets are on the bottom)
Vase mode 150mm - TESTED with 0.6 nozzle with 0.32 layer height
bucket height is 150mm
4x holes for magnets, use of glue is recommended (to prevent magnets catapulting or falling off from prime bucket during emptying)
Check magnet holder outer walls. It was brought to my attention possible problem with magnet holders and perimeter extrusion width
![]() | correct magnet holder |
|---|---|
![]() | incorrect magnet holder Check Print setting - Advanced - Extrusion width: Perimeters and External perimeters It should be set to less than or equal to 0,8mm or it will skip the holder outer wall |
Vase mode 240mm - TESTED with 0.6 nozzle with 0.32 layer height
bucket height is 240mm
4x holes for magnets, use of glue is recommended (to prevent magnets catapulting or falling off from prime bucket during emptying)
Check magnet holder outer walls.
Standard (solid) mode 150mm - TESTED with 0.6 nozzle with 0.32 layer height
Should allow some multicolor customization
bucket height is 150mm
4x holes for magnets, use of glue is recommended (to prevent magnets catapulting or falling off from prime bucket during emptying)
Standard (solid) mode 240mm - TESTED with 0.6 nozzle with 0.32 layer height
Should allow some multicolor customization
bucket height is 150mm
4x holes for magnets, use of glue is recommended (to prevent magnets catapulting or falling off from prime bucket during emptying)
Project files:
Edits:
20260813 - added 240mm Tall vase bucket, WIP, need testing
20260814 - solid 150mm bucked tested and verified, solution for missing outer wall on magnet holders in vase mode
20260815 - Vase mode 240mm bucket tested and verified, added version for 20x6x3 magnets(only Tall vase), verified functioning with Handle-Hatch mod, updated description; added Tall solid, WIP, need testing
20260817 - Solid 240mm tested and verified
20260824 - reuploaded 240mm bucket with 20x6x3 magnets, as I was notified on problem with its scale
20260831 - added clarification about Prusa original extended bucketUnless something comes up, this project is now complete

