1 / 4
Tengwar d6 — a 20 mm die numbered in elvish duodecimal numerals — zdjęcie 1
1 / 4

Tengwar d6 — a 20 mm die numbered in elvish duodecimal numerals

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 20 mm six-sided die whose pips are replaced by authentic Tengwar duodecimal numerals.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution

A normal six-sided die in every way that matters at the table — except the pips are gone, and each face carries an authentic Tengwar duodecimal numeral instead.

Opposite faces sum to 7, and the 1-top / 2-front / 3-right corner is the right-handed arrangement standard Western dice use, so it drops straight into any game. The four side numerals read upright with the die sitting on the table, the top numeral reads upright from the front.

How to read it

The numerals are curls on a stem, so they are counted, not memorised: 1 = one curl, 2 = two curls, 3 = three curls, 4 = stem, 5 = stem + one curl, 6 = stem + two curls.

Why the die is 20 mm

Because the numerals are the constraint, not the die. Tengwar numerals are curls joined by hairlines, and scaled onto a 16 mm face the narrowest stroke measures about 0.40 mm — under one nozzle width, so the slicer drops it and the glyph prints as disconnected blobs. Two changes fix it, and both are needed: a 20 mm die, and a 0.30 mm dilation of every outline before it is engraved. The bundled check.py gates this rather than trusting the render — it erodes each glyph by 0.40 mm per side and requires the result to stay a single connected region, which proves every stroke is at least 0.80 mm (two extrusion widths) wide.

What you print

tengwar_d6.stl — the die, numerals engraved 0.9 mm deep. Print six for a full handful. tengwar_d6_numerals.stl — optional: six coordinate-locked inlay plugs that exactly fill those recesses, for a second AMS colour.

Single colour: print the die on its own and brush acrylic into the recesses if you want contrast.

Two colour (AMS): select both STLs in ONE file-open action and answer yes to "load as a single object with multiple parts", then assign the plugs filament 2. One assignment, coordinates untouched, so the numerals can only land in their own recesses. If the plugs end up beside the die, the files were opened as two separate imports — re-import both in a single action.

Print

0.2 mm layers, 0.4 mm nozzle, no supports, no brim. The die is exported lying on its "1" face, deliberately: that recess is the only one the slicer has to bridge, and glyph 1 is the smallest, so it spans the least air. The rounded edges still leave a 16.8 x 16.8 mm flat contact patch, plenty of adhesion on its own. Printed in blue with a yellow inlay — every hairline came out connected and the plugs sit flush.

Source

tengwar_d6.scad is fully parametric: die size, edge radius, glyph box, outline dilation, engrave depth and inlay gap are all variables at the top of the file.

Tagi