iPhone 17 Pro / 18 Pro Standby Mode Dock – TechWoven Case (Scott Yu-Jan & OVERWERK)

A customized version of the Standby Mode Dock originally created by Scott Yu-Jan & OVERWERK, adapted specifically for the iPhones 17 Pro and 18 Pro with the TechWoven case.

The dimensions were customized using Marlfox's fully parametric Fusion 360 tool. The resulting dock allows the iPhones 17 Pro and 18 Pro to remain inside the TechWoven case while charging in StandBy mode — no need to remove the case.

Original Model

This 3D model was originally created by Scott Yu-Jan and OVERWERK.

Original model on MakerWorld:
iPhone Standby Mode Dock – Original by Scott Yu-Jan & OVERWERK

Parametric Customization

This remix was created using Marlfox's parametric Fusion 360 tool, which allows the original design to be adapted to different iPhones and cases.

Marlfox – Parametric iPhone Standby Mode Dock

For this remix, the geometry was specifically adapted for the iPhones 17 Pro and 18 Pro + TechWoven case.

MagSafe Integration

The MagSafe charger opening has also been specifically adjusted for this version.

The MagSafe charger can be inserted securely without permanently gluing it into the dock, so it can still be removed if needed.

The magnet does not pull the iPhone out of the dock when operating the clicker.

Printing

I printed this version in PETG with the following settings:

• filament: Prusament PETG Chalky Blue and Urban Grey (1.75 mm)

• Layer height: 0.2 mm

• Outer perimeters: 4

• Infill: 8% Gyroid

• brim: 5 mm

• Outer perimeter speed: 50 mm/s

• Seam: Rear

• Scarf-fuge: enabled

• Supports: only required for the large overhang where the clicker is inserted

The 4 outer perimeters also leave enough material for optional post-processing and sanding if a smoother surface is desired.

The model can be printed without extensive supports; only the large overhang mentioned above requires support.

Tested

This remix has been printed and tested with an iPhone 17 Pro in the TechWoven case. Charging works reliably while the phone remains in the case.

Happy printing!

Edit: Compatibility note – iPhone 18 Pro

Based on the publicly available dimensions of Apple's iPhone 18 Pro TechWoven Case, the dock is expected to be compatible with the iPhone 18 Pro when used with this case.
The dimensions appear to be sufficiently close to those of the iPhone 17 Pro TechWoven Case for the dock to fit. However, I have not physically tested this combination, so compatibility cannot be guaranteed.
If you experience any fit issues, please don't hesitate to leave a comment or contact me. Any feedback, especially from users who have tested the dock with an iPhone 18 Pro and its TechWoven Case, would be greatly appreciated and will help me improve the design.

Thank you!