Peak Design Mobile to 1/4-20 Thread with Magnets and SlimLink Hard Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapt a magnetic, hard-locking mount for Peak Design's Mobile Case to any 1/4-20 thread
- Ocena
- 5 / 5
- Polubienia
- 88
- Pobrania
- 366
- Wydruki
- 0
- Wyświetlenia
- 3979
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Update September 2024: This version is no longer recommended. See much-improved new design here:
Update March 2024: Updated with two-sided compliant closure.
---
A magnetic mount with compliant “hard lock” mechanism to adapt Peak Design's Mobile Case to any standard threaded accessory. I also include a version without any mounting features on the outside, for remix purposes.
Requires 4x 10mm x 3mm refrigerator magnets and a pause at the appropriate layer to embed them in the print.
Requires Peak Design's Mobile Everyday case or Universal Adapter for SlimLink compatibility.
My first print so far with this design was with:
- Prusament PLA Galaxy Silver
- 0.15mm layers, QUALITY preset
- 4 perimeters
- 30% gyroid infill
- supports to the base only
- printed with the boss/phone side down on the plate
This prints with a rather tight SlimLink – it is a very secure mount and requires a bit of fidgeting to get it to come off at first. I expect the securing tabs to wear out a bit and get easier to remove over time.