Small Tracts Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Tracts Holder for Tracts around 84mm by 108mm.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Printing
Material: PLA but will probably print in most stiff materials
Layer height: 0.30mm is fine especially if printing a lot
Bed adhesion: you need decent adhesion, because the first layer isn't that big. Unfortunately some warping is common with the given design constrains
Features

The irregular hexagonal opening on the front is designed to be easy to print without sacrificing usability or introducing sharp edges. It serves two purposes: it lets you quickly see whether there is at least one tract inside, and provides enough access to use your thumb to slide one out or hold the stack securely in place.
The edge at the top is to make inserting tract easier and quicker.
Final Notes
It has been tested in the field by friends and family, so far has been a success. The only mayor hurdle is the bed adhesion can be a bit troublesome. But so far i found my design to be a greatly appreciated.
