CR10SE 5015 Fan Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CR10SE Fan shroud that utilizes a 5015 fan attached via an adapter for better direct airflow with 1 fan.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a CR10SE fan shroud that maximizes direct airflow for parts cooling. Remix of Andrey E's Fan shroud to resize and repositions vent hole to accommodate 5015 fan via Tim Appleby's adapter. I have made an optional cut to the adapter to allow for more air draw from fan, I suppose this is optional but it made me feel better. This will be louder than just using the 5015 adapter in stock shroud, but I have found that the amount of direct cooling is unmatched from any other single fan solutions I've seen so far without crazy modification. If you want an ultra quiet solution, this is not for you.
I saw some concerns from original post station that cr-touch may be pushed by the shroud. This may depend on printer tolerances but have verified that the shroud has enough adjustment to avoid touching cr-touch while still maintaining a 3 mm or more gap between air vent and the silicone sock around the top of nozzle/bottom of heat block.
I personally printed it in PETG, but print in whatever material you use that has the highest heat tolerances. So far I have not had any issues printing PETG or PLA.
Use one heat insert as shown in pictures to allow for adapter mounting.
YOU WILL NEED:
1 - Fan Shroud
1 - 5015 fan cut down per Tim Appleby's instruction
1 - 5015 fan adapter from Tim Appleby's page or found here
1 - m3x5 heat insert
1 - oem parts cooling fan screw
3 - slightly longer than oem m3 screws (shroud is not countersunk so oem screws are too short)