1 / 4
RV Washer to back stripped fender mount screws — zdjęcie 1
1 / 4

RV Washer to back stripped fender mount screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a additional part to help with a stripped screws on the RV Plastic Fenders.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
19
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Multiple screws on my RV Fender have come loose and after tightening them multiple times they ended up stripped as they don't sink into anything substantial other then the j-Channel thin sheet metal.  This washer will allow a #10 screw something to grab if the hole is stripped out.  It uses a 3/4 inch wrench on the back side to hold it in place while tightening the screws, due to high friction I hope that it will also keep it from comming loose over time.  It could be made from PLA, PETG, PC, ASA or any other materials that will hold up to outside use but is hidden behind the fenders so UV light will not degrade them.

I would also recommend some better screws you can find them on Amazon search for Trim Screws, #10 x 3/4in, Black Phosphate Screws and you should find many.  My RV uses #10 screws if you have larger or smaller you may have to edit the hole size small to fit a #8 or drill the hole bigger for a #12 screw.  I am assumeing most RV use a #10 screw for this attachement.  The Trim Screws have a larger area to grab on as one of mine pulled through the fender and I had to use a larger trim screw to secure it.  The Tirm Screws will clamp better and also help to prevent pull through due to it larger size clamping the fender.

Tagi