Sovol Zero Minimalist Toolhead Shroud - "The Power Loader"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minimalist shroud with improved airflow. Compatible with the K2 + hotend upgrade.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 11
- Wydruki
- 1
- Wyświetlenia
- 118
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a minimalist toolhead shroud that is compatible with the K2 + hotend upgrade. It should also work fine with the oem hotend. This allows for (to my eyes) better part cooling and better visibility of the nozzle during printing. This shroud is also compatible with @shoeys_2048431 's Belt Clamps
Please note, I use a smaller 2510 hotend fan, which works just as well as the oem. I have not test fit this with the oem hotend setup, but it shoud fit fine.
You'll want to glue a pair of 4x2mm magnets into each hole of the 4 holes. Be careful to match the magnet polarity to the toolhead.
You can find the mcu fan mount here.
Print Settings:
4 walls
30% gyroid infil
ABS, ASA, PPA-GF, or any other heat resistant filament.
Print face down with painted supports on the green areas. Depending on your filament, you may be able to get away with not adding supports to the clips.