Stubby Bit Holder and Driver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A compact way to organize 7 double ended screw driver bits, such as in a MEGAPRO Replacement Multi-Bit Refills pack.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I added a refill pack of MEGAPRO hex key bits to my grab and go tool roll. After a few months the zip bag they came in started to disintegrate. Seemed like a new bit holder was in order. This one holds all 7 of the refill pack, 6 on the outside and one raised slightly in the middle. I don't think I'm going to be doing any serious screw turning with this, but it will work as a stubby in a pinch.
No supports necessary. There is a triangular one (my favorite) that is a little more pleasant to grip and a round one that is slightly smaller in diameter. The hex in the top side allows you to stack several together if you need to pack more than one refill set.
I find that placing the spring-loaded ball facing into the bit holder gives each bit just the right amount of hold, but feel free to print off the "Calibration Check". Each size step in that part represents a 1% scale up (or down) of the 'stock' size of the holder (scale factor indicated on the bottom of the calibration check). Feel free to scale your driver to fit bits you have!