Adapter for SimCore PF1 Pedal-Pad on Heusinkveld Sprint
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SimCore PF1-T (Throttle) and PF1-B (Brake) Pads. For Heusinkveld Sprint only.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This part (specially the brake) have to take quite high forces. Therefore I highly recommend to print it with Fibre reinforced filament (ie. PETG-CF or PA-CF). I finally used PA12-CF. Don't even think about PLA.
0.2 mm layer height
5 walls
5 bottom and 5 top layers.
25 % infill with 3d Honeycomb oder TPMS-D Cell
I recommend to use PLA for the interface between the support and the model for easy removal.
Per pedal you need two additional M6x10 scews
Version 1:
Remove the original Heusinkveld Pedal Plate und use the srew to mount the adapter to the pedal.
Use M6 screws to mount the SimCore Plates to the adapter
Version 2:
For more stability I increased the thickness and prepared the hole for a threaded insert. Use a short M4x4.0 insert. I recommend to melt the insert from the front side (where the plate ist monted) You need an additional M4x8 flat head screw an a washer with at least 1mm.
- V2a: I incresed the thicknes by 1mm to make it more rigid. (V2 files removed)
The Picture shows a test piece printed in ASA. It works, but for long term use I would recommend carbon fibre reinforced materials.
