Inland MK47 Retro Case - Sneed SN47
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Retro-styled case for the Inland MK47 inspired by vintage Cherry and IBM keyboards
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
The Sneed SN47 is a retro-styled 3D-printed case for the Inland MK47, inspired by vintage Cherry and IBM keyboards. It is directly compatible with the MK47 plate and PCB assembly and reuses the original self-tapping mounting screws.
A separate collection of individual parts is also included for duo-tone accents or bottom lettering - these are labeled with the prefix "sep_". For these versions, load the components for each half as a single multi-part object.
BOM
Part | Spec | Qty | Note |
|---|---|---|---|
Case screws | M2_0.4x5 mm | 5 | Flat head recommended. Socket head may not clear the PCB |
Heat-set inserts | M2x4x3.2 mm | 5 | |
Case weights (optional) | 1/4 oz low profile | up to 14 | 16 mm × 19 mm × 3 mm CK Auto PN# CKsafeAWW005Black01 |
Plate screws | See note | 6 | Reuse original MK47 self-tapping screws |
Feet/bumpons | 8mm diameter | 4 | Self-adhesive cabinet/furniture pads |
Assembly
The plate screws may not feel like they are well-threaded in the mounting bosses. If necessary, a small amount of PTFE tape can help tighten particularly loose screws, though in testing it has not been an issue.
Install the M2 heat-set inserts into the pilot holes in the bottom half of the case. The inserts should sit flush with or slightly below the mating surface.
If using weights, place them in the rectangular recesses in the bottom half. Adhering them in place is recommended to prevent shifting or rattling during use.
Align the top and bottom halves and loosely install the center M2x5 screw. Install the remaining four screws, then fully tighten all five once they are in place. If using weights, the adhesive pads will need to compress slightly while tightening.
If you have not already done so, remove the plate/PCB assembly from your MK47 and retain the six self-tapping plate screws. Only these six screws need to be removed. Leave the screw securing the PCB to the plate installed and keep the assembly intact.
Place the MK47 assembly into the SN47 case. Press it firmly into position until fully seated. Reinstall the six self-tapping plate screws to secure the plate to the case.
Credits
Valaadus on Discord for inspiring the thermal accent around the USB port and color accents, and for working through printing gremlins.
The 40% Discord community for being an incredible group of helpful people and an invaluable resource in learning to do this design work.