Attachment points for Nerf Stryfe rails. You can do both or just one.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attachment points for Nerf Stryfe rails. You can do both or just one.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 5
- Wydruki
- 1
- Wyświetlenia
- 141
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Nerf Stryfe Rail Attachment Points
Nerf Stryfe Rail Attachment Points
Description:
Description:
Attachment points for Nerf Stryfe rails. You can do both or just one.
Get the rails for this kit from this model:
https://www.printables.com/model/1703920-stryfe-muzzle-bcar
https://makerworld.com/en/models/2730208-stryfe-muzzle-bcar
Materials:
2x M3x8mm Pan Head Screw
2x M3 nuts
I used PETG with 3 walls, 15% infill. PLA should also be fine.
Instructions:
Print the models and clean up any edges.
Upper:
1) Open the shell of the Stryfe.
2) Swap the upper sling attachment point with the adapter. It should sit so that the top is flat.
3) Close up your Stryfe.
4) Place the upper rail over the attachment point.
5) Screw it in. It should be snug, but do not over-tighten - it is plastic.
Lower:
1) Insert a nut into the inner holder.
2) Thread a screw through the rail and into the side of the attachment point opposite the nut and screw it in. Make sure the screw and nut do not stick out past the hole made for the nut.
3) Repeat the process for the other.
4) Slide the adapter over the lower NStrike rail. You will probably have to tap it in - this is intentional because you do not want your attachments to move.