Nobsound NS-01G Amp mount

I'm not an audiophile but wanted a small amp to power some speakers around my house and ended up with a few of these low cost Nobsound NS-01G amps. I'm sure the audio quality isn't great, but if you're looking at this model you probably already decided it was good enough!

I have two designs here, one of them is for mounting with machine screws, the other is for mounting with fasteners with larger heads e.g. some sort of machine screw perhaps (I'm actually using the side mount version under my desk with wood inserts and socket cap screws.

I've printed these without support, vertically, and in PLA which is fine for my purposes. You'll note that if printed with a vertical orientation the "clips" on the side have layer lines that result in a very brittle / easily snapped bending. As a result, you should probably only attempt to remove the amp from the holder very very carefully / gingerly, otherwise you WILL snap off the clips. That said, the clips are not really needed generally as the tolerances are such that the friction is plenty if you're not mounting the holder upside down.

And speaking of orientation, note that the amp can be put in either direction in the mount, it doesn't matter all that much although the clips aren't all that robust when printed in the vertical orientation so be mindful that if you're constantly plugging and unplugging stuff (e.g. a 3.5mm audio cable) you might eventually end up with a failing clip with this design. To be honest I haven't used this enough yet to know.