Filament Dry Box based on Ezy Storage 11.4L IP67
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage / dispensing box for 3d printer filaments based on Ezy Storage 11.4L IP67 Waterproof Storage Box
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Basically what it says on the tin - using Ezy Storage 11.4L IP67 Waterproof Storage Box to reduce moisture ingress for hygroscopic filaments.
Assembly
1. Drill the 4mm hole for PTFE tube. Use wood drill bit, go easy on the pressure to avoid cracking the plastic
2. Put PTFE tube into the adapter, then into the hole in the box. Apply glue (Loctite 406 works like a charm) to the PTFE adapter housing, press it onto the box surface & hold
3. Bearings are a tight fit - go easy
4. M8 150mm bolt is a bit too long, needs a bit of trimming - I honestly don't remember how I figured out the length, so good luck there
5. Most tricky part is aligning the axis and the pads. First, insert the lid pad into the lid. Then, with lid laying flat, put the spool assembly with the bolt & bolt head side pad attached on top of it. Have a bit of double sided sticky tape on the bolt head pad. Carefully put the body of the box on top of it, don't mess up the alignment. Lock all the sides. Press on the bottom of the box to make sure that sticky tape has enough contact. Now take whole thing apart making sure the bolt head pad remains connected to the box. Use a marker to draw lines around the box. Detach the pad from the inside the box, remove sticky tape, apply 406 glue to the pad or inside the marked area, and carefully re-position the pad inside the marked area.
BOM
1 x Ezy Storage 11.4L IP67 Waterproof Storage Box
2 x 608 ball bearing assemblies
1 x M8 x 150mm Hex Head Bolt
1 x PTFE tube adapter