Pool Noodle Connector Set - Straight, L, T and X

Four barbed connectors that let you build rafts, frames and play structures out of ordinary pool noodles.

WHAT YOU GET

• Havuz_Makarnasi_Baglanti_Duz.stl -- straight coupler

• Havuz_Makarnasi_Baglanti_L.stl -- 90 degree elbow

• Havuz_Makarnasi_Baglanti_T.stl -- T junction

• Havuz_Makarnasi_Baglanti_X.stl -- 4-way cross

• 00_Dortlu_Baski_Tablasi.stl -- all four on one plate

KEY DIMENSIONS (mm)

• Shaft nominal diameter: 17.6

• Retaining barb diameter: 19.4

• Arm length: 59

• Target noodle bore: 18-21 dia

PRINT SETTINGS

• PETG recommended, ASA if it will sit in direct sun

• 0.24 mm layers, 5 walls, 35% infill

• Print on the largest flat face; optional support under the centre of the L/T/X parts only

ASSEMBLY

Twist each arm into the centre hole of the pool noodle as you push. The barb grips going in and resists pulling out.

PLEASE NOTE

These connectors are NOT flotation or life-saving equipment. Never rely on them for buoyancy, and always supervise children in and around water.

Every dimension is in millimetres. Tolerances on friction fits are 0.20-0.35 mm, which suits most FDM printers, but printers and filaments vary - print one part first and check the fit before you print a batch.

License: Creative Commons Attribution-NonCommercial-ShareAlike 4.0 (CC BY-NC-SA 4.0). Print it, remix it, share it - just credit the design and do not sell the printed parts or the files.