1 / 1
Folding Hanger for Wet Swimwear and Socks — zdjęcie 1

Folding Hanger for Wet Swimwear and Socks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Opens to 230 mm for a swimsuit and four pairs of socks, folds to hook size for the suitcase.

Ocena
0 / 5
Polubienia
3
Pobrania
0
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Opens to about 230 mm to dry a swimsuit and four pairs of socks, then folds down to hook size for the suitcase.

WHAT YOU GET

• 01_Merkez_Kanca.stl -- centre hook

• 02_Sol_Katlanir_Kol.stl -- left folding arm

• 03_Sag_Katlanir_Kol.stl -- right folding arm

• 04_Mentese_Pimi_2_Adet.stl -- hinge pins (print 2)

• 00_Tum_Parcalar_Baski_Tablasi.stl -- all parts on one plate

KEY DIMENSIONS (mm)

• Open width: approx. 230

• Small hangers per arm: 4

• Pivot: 4.4 dia

PRINT SETTINGS

• PETG, 0.20 mm layers, 4 walls

• All parts print flat, print 2 of the pin

ASSEMBLY

Bring the rounded ends of the arms up to the two pivots on the centre piece and push the pins through. The arms swing out in use and fold in towards the centre for travel. Drape the swimsuit over the arms and hook socks into the open slots.

Every dimension is in millimetres. Tolerances on friction fits are 0.20-0.35 mm, which suits most FDM printers, but printers and filaments vary - print one part first and check the fit before you print a batch.

License: Creative Commons Attribution-NonCommercial-ShareAlike 4.0 (CC BY-NC-SA 4.0). Print it, remix it, share it - just credit the design and do not sell the printed parts or the files.

Tagi