Replacement Gas Can Cap for 10L Jerry Can (PETG 3D Printed)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
jerry-can gas-can cap canister replacement jerrycan fuel petrol custom
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 119
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Heavy-duty replacement screw cap for a standard 10-liter plastic fuel/gasoline canister (Jerry Can), custom-designed for 3D printing. Perfect if your original factory cap is cracked, leaking, or lost.
The internal thread was designed by taking physical measurements directly from the canister's neck. Tested in real-world conditions: printed in PETG with 100% infill, it successfully holds gasoline (petrol) without any leaks or plastic degradation.
Sealing Gasket Options (CRITICAL FOR LEAK PREVENTION):
Original Gasket: The rubber sealing gasket can be salvaged and reused from your old, cracked factory cap.
Custom Rubber Gasket: If the original gasket is lost, you can easily cut a new one from a sheet of fuel-resistant (NBR/Viton) rubber. Gasket dimensions: Outer Diameter (OD) = 38 mm, Inner Diameter (ID) = 28 mm, Thickness = 2 to 3 mm.
DIY PTFE (FUM) Tape Hack: If fuel-resistant rubber is unavailable, you can create a temporary emergency seal using standard plumbing PTFE (FUM) tape. Fold the tape into multiple layers, twist it into a tight cord/rope (approx. 4-5 mm in diameter), and pack it tightly into the annular sealing groove inside the cap before screwing it on.
My Print Settings:
Material: PETG (strictly recommended for fuel resistance and durability).
Infill: 100% (solid, to prevent fuel fumes leaking through micro-voids between layers).
Nozzle Diameter: 0.6 mm
Layer Height: 0.30 mm
Supports: Not required if printed flat on its top surface.
Clean solid geometry, exported via STEP AP214 and STL.