1 / 1
Hammond 1590UFL Flanged Enclosure 45 Degree Bracket — zdjęcie 1

Hammond 1590UFL Flanged Enclosure 45 Degree Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for the Hammond 1590UFL Flanged Case. The mounting holes must be drilled manually.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
8
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Public Domain

A mount for the Hammond 1590UFL Flanged Case. The holes are not drilled on this, and should be done manually.  The original version of this had no diagonal support, and the two WiFi looking antenna fins were likely to break off. This was made in FreeCAD 1.0.0 on Debian 13 and source has been included.

There are two errors with this. One the holes are not included (I was too lazy to do it and I'm not sure they would print without supports, given the angle.). Two, the base uses b-splines that are not 100% identical, and as a result there is a tiny bit of overhang on one of the diagonal supports. Anyone is welcome to fix this, as the source is included.

The layers are 0.25" thick. There are three mounting holes, as well as some cutouts that can be used with fender washers if those three are unavailable. It slices with minimal supports (though I would recommend selecting 'everything' in Prusa Slicer. It prints in 6 and 1/2 hours on a stock Prusa i3 Mk3.

Tagi