1 / 5
Voron Camera Mount for UGREEN FineCam Lite Webcam — zdjęcie 1
1 / 5

Voron Camera Mount for UGREEN FineCam Lite Webcam

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A camera mount to see what your printer is doing.

Ocena
0 / 5
Polubienia
2
Pobrania
5
Wydruki
0
Wyświetlenia
98
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This is a custom shell for the UGREEN FineCam Lite WebCam.

Image Quality

I think they look good, the webcam supports 1080p and here is how it looks for my printer (I haven't bothered configuring the options or setting a manual focus).

And this is how it is configured in crowsnest:

[cam 1]
mode: ustreamer                         # https://docs.mainsail.xyz/crowsnest/faq/backends
port: 8080                              # HTTP/MJPG stream/snapshot port
device: /dev/video0                     # See log for available devices
resolution: 1920x1080                   # <width>x<height> format
max_fps: 30                             # If hardware supports it, it will be forced, otherwise ignored/coerced.
custom_flags: --rotate 180 -l           # You can run the stream services with custom flags.
v4l2ctl: exposure_dynamic_framerate=1   # Add v4l2-ctl parameters to setup your camera, see log for your camera capabilities.

How to disassemble

The front of the camera has a plastic cover that hides screws. This must be removed. I recommend heating it up with a hot air station or with a 3d printer bed:

After that you should have access to the PCB which can be removed by unplugging the USB connector and removing a few screws:

You might have to snip off or desolder the microphone.

I strongly recommend adding a bit of hot glue or silicone glue to the connector cables to prevent them from ripping off. If it already happened, the connector is a MX1.25 (seems to be called PicoBlade).

Make sure to keep the screws, two of them will be used for mounting the PCB to the printed camera shell. I think I used the ones that were used to mount the PCB in the original shell, but it has been so long that I don't remember where the screws are from.

Routing the cable

To have it mounted in the front above the door, I cut off the head of a slim USB cable. The original cable has ferrite bead on the cable, which caused trouble with routing. I tried cutting it out and soldering the ends together, but that resulted in a bad connection. This is what a ferrite bead looks like

I routed the cable through the left side of the extrusion, then through the Z motors into the electronics bay. I strongly recommend printing some cable covers. This one works well with my extrusions, but you might need different ones 

Alternative

My model has been in the work for over a year now. In that time someone else made a different shell for this camera, you can find it here:

Why is there a hole in the model?

You might be wondering what this is for

This was supposed to be for a USB-C breakout board that looks like this

it works, but I abandoned it, because I could not find an usb c cable that fit where I wanted to mount it.

Tagi