Fanttik V8 Slim Adapter for inflating and deflating pool floats and air mattresses
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With these adapters for the Fanttik V8 Slim, you can inflate and deflate pool floats and air mattresses.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
With these adapters for the Fanttik V8 Slim, you can inflate and deflate pool floats, air mattresses, and similar inflatable toys.
The nozzle is required for both functions and is simply attached using a bayonet connection. The nozzle has a diameter of 9 mm (23/64 inches). Other diameters can also be offered upon request.
The adapter is only needed to suck the air back out, helping to prevent the annoying process of manually folding and squeezing the air out of inflatable toys.
When attaching the adapter, make sure it is installed correctly, as one side of the bayonet connection is slightly thicker.
When inflating or deflating, the valve must be slightly pressed in as usual to allow the air to flow in or out.
The adapter was printed using PETG, with a 0.2 mm layer height and 10% infill.
Mit diesem Adaptern für den Fanttik v8 slim können Schwimmreifen/Luftmatratzen oder ähnliches Badespielzeug aufblasen oder Luft herausgesaugt werden.
Die Düse wird für beides benötigt sie wird einfach mit einem Bajonettverschluss befestigt. Der Durchmesser der Düse beträgt 9mm (23/64 Zoll) auf Wunsch kann ich auch andere Durchmesser anbieten.
Der Adapter wird nur benötigt um die Luft wieder heraus zu saugen um nerviges zusammenfalten von dem Badespielzeug zu verhindern. Beim montieren des Adapters ist darauf zu achten das er korrekt montiert wird da eine Seite vom Bajonettverschluss etwas dicker ist.
Beim Aufblasen oder absaugen der Luft muss das Ventil wie immer etwas leicht gedrückt werden damit die Luft hinein/raus strömen kann.
Gedruckt wurde mit PETG mit einer Schichthöhe von 0.2mm und 10% Füllung