1 / 3
EBB42 Gen2 PCB to K1 Series Printhead with Cartographer — zdjęcie 1
1 / 3

EBB42 Gen2 PCB to K1 Series Printhead with Cartographer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows the use of a stock printhead carriage with the EBB42 Gen2 board and Cartographer.

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
65
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This was made for using the EBB42 Gen2 board on a K1 series.  The cable holder is for using the stock K1 cable with a XT30U (2+2) soldered with heat shrink. 

Newer style Creality 3010 fan or HoneyBadger 3010 with the recessed mounting points, only uses the top 2 screws above heatsink.

Carto wiring passes thru a chase in the blower housing, wiring with pins slides thru then terminate into connector.

Uses 5 - M3 4X4.5 heat inserts

Part cooling fan slides in from front. Watching how wiring is placed between board and heatbreak fan is important. We used the extra adapter cable wires that came with the Microswiss hotend to make short cables for future hotend work easier - no need to remove board to access connectors.

Tagi