Nobsound Headphone Tube Amp and Tube Preamp Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a simple design to stack the Nobsound NS-10P and NS-08E headphone pre-amp and amplifiers.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Just a simple design to stack the Nobsound NS-10P and NS-08E headphone pre-amp and amplifiers.
I've had these on my desk for years and was never happy with them sitting side-by-side, so I finally decided to print a solution. I removed the rubber feet from the front of the units, so they would sit flatter in the rack, and re-used the feet on the bottom of the rack to keep it from sliding on my wooden desktop. Other than that, its a zero effort print.
Make sure you print it face down (see photos if you aren't sure) and the only supports you should need are for the two cross-bar pieces at the back of the rack.
If you use this for any other models of desktop amp/pre-amp please share what models fit or remixes if you had to make changes to fit your own.
I printed in Elegoo PETG-GF, mostly for the finish.