Sprinter Door Grommets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D printable version of a door grommet between the door and vehicle body on a VS30 / W907 or similar.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 152
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This part can be used as a replacement for the brittle OEM version on a VS30 / W907 Sprinter. I broke mine while installing rear speaker wires, couldn't find a replacement, and so created this one. I have used two of them on my van. They have been in use for over 12 months without any problems. YMMV.
There are actually two parts: the hard plastic replacement for the brittle OEM part, and also a tool that makes it easy to press the indents from the INSIDE of the door, to release the springy-finger-locks. This makes the part easily removable.
Print in PETG or ASA or equivalent. Do not print this part using PLA, or it will melt on a warm day, and it's likely your wires will rub on the frame and be damaged. I used ASA, and it turned out great.
I have no idea what it's called, and it's not clear that Mercedes sells a replacement without the wire hose attached. Their part may be A0009974951. My version is not a replacement, but does the job.
It's unclear if this will fit a NCV3 / W906 van. It seems to use the same part, but I don't have one to test.
Note that, it is published here so you can print it for free. Free as in beer, eagles, USA, and Germany.
Obviously it took a bunch of my time and testing to make it work. I feel I've gotten enough from the #vanlife community that I wanted to make it available to other makers. However, it is not licensed for you to sell it.