1 / 4
Inland Reusable Spool V2 Adapter for Filament Storage 2026 — zdjęcie 1
1 / 4

Inland Reusable Spool V2 Adapter for Filament Storage 2026

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for Inland Reusable Filament Spool to fit the rewinder used in the Filament Storage 2026 system.

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
44
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
GNU General Public License v2.0

Dimensions used:

  • Spool Hole Diameter: 54.5

  • Spool Width: 66.4 (actual 66.8)

  • Spool Cutout Diameter: 80.5

  • Spool Cutout Depth: 2.3

  • Angle on center hub: 10 degrees

Key:

  • CB = Cardboard

  • PC = Plastic Closed Center Hub

  • PO = Plastic Open Center Hub

  • RS = Reusable Spool

  • 3D = 3D Printed Spool

Print settings:

  • .20mm Structural

  • Infill: Gyroid

  • Supports: None

  • Variable layer height - Adaptive .50

Extra notes:

  • I had problems printing with the actual spool width, so I decreased it to force OpenSCAD to generate a slightly thicker adapter.

  • I created a shape that can be used to cut appropriate angle in the adapter. Center and place .3mm above surface so the outer edges do not get too thin.

Source:

  • Measurements were taken using a digital caliper.

  • Hole diameter was measured using the inside jaws.

  • Spool width was measured by placing the spool on the flat surface and using the depth gauge.

  • In both cases, multiple measurements were taken and averaged.

  • Measurements of angled portion of center hub were taken with digital caliber and entered into online calculator to determine approximate angle.

Photos:

  • Adapter in spool to make sure it fits

  • Spool in assembled test lid to make sure it spins freely

  • Inside of adapter showing angled layer lines

  • Portion of adapter showing how fit on angled center hub

Bonus:

I also made an adapter for the V1 spool that I have, but since they are no longer sold, I did not want to spend too much time printing and verifying. Measurements taken using digital caliper as above. Spool Hole Diameter: 51.5 Spool Width: 60 NO GUARANTEES