Inland Reusable Spool V2 Adapter for Filament Storage 2026
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for Inland Reusable Filament Spool to fit the rewinder used in the Filament Storage 2026 system.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 44
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- GNU General Public License v2.0
Dimensions used:
Spool Hole Diameter: 54.5
Spool Width: 66.4 (actual 66.8)
Spool Cutout Diameter: 80.5
Spool Cutout Depth: 2.3
Angle on center hub: 10 degrees
Key:
CB = Cardboard
PC = Plastic Closed Center Hub
PO = Plastic Open Center Hub
RS = Reusable Spool
3D = 3D Printed Spool
Print settings:
.20mm Structural
Infill: Gyroid
Supports: None
Variable layer height - Adaptive .50
Extra notes:
I had problems printing with the actual spool width, so I decreased it to force OpenSCAD to generate a slightly thicker adapter.
I created a shape that can be used to cut appropriate angle in the adapter. Center and place .3mm above surface so the outer edges do not get too thin.
Source:
Measurements were taken using a digital caliper.
Hole diameter was measured using the inside jaws.
Spool width was measured by placing the spool on the flat surface and using the depth gauge.
In both cases, multiple measurements were taken and averaged.
Measurements of angled portion of center hub were taken with digital caliber and entered into online calculator to determine approximate angle.
Photos:
Adapter in spool to make sure it fits
Spool in assembled test lid to make sure it spins freely
Inside of adapter showing angled layer lines
Portion of adapter showing how fit on angled center hub
Bonus:
I also made an adapter for the V1 spool that I have, but since they are no longer sold, I did not want to spend too much time printing and verifying. Measurements taken using digital caliper as above. Spool Hole Diameter: 51.5 Spool Width: 60 NO GUARANTEES