Spool Holder to suite PrintDry spindles.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The rubber spool holders supplied with my PrintDry did not fit the centres of the filament spools I have been using.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 126
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The rubber spool holders supplied with my PrintDry did not fit the centres of the filament spools I have been using. this resulted in the spools falling off when printing direct from the dryer, which resulted in a couple of failed prints.
These spool holders use the original aluminium spindles and fit spools with 73mm holes and up to 70mm wide.
Print instructions
- You will need to print 2 per spindle.
- 5 walls
- 15 to 20% infill
- Materials to suite your drying temp, see Material Notes below
- No supports required
Material Notes
The PrintDry can heat up to 75 Celsius, I only use 45 celsius so mine are printed in PLA+ with no problem so far. I suspect that if had filament in the dryer for and extended period I would need to reprint in PETG or ABS.