Spool Holder to suite PrintDry spindles.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The rubber spool holders supplied with my PrintDry did not fit the centres of the filament spools I have been using.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 126
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The rubber spool holders supplied with my PrintDry did not fit the centres of the filament spools I have been using. this resulted in the spools falling off when printing direct from the dryer, which resulted in a couple of failed prints.
These spool holders use the original aluminium spindles and fit spools with 73mm holes and up to 70mm wide.
Print instructions
- You will need to print 2 per spindle.
- 5 walls
- 15 to 20% infill
- Materials to suite your drying temp, see Material Notes below
- No supports required
Material Notes
The PrintDry can heat up to 75 Celsius, I only use 45 celsius so mine are printed in PLA+ with no problem so far. I suspect that if had filament in the dryer for and extended period I would need to reprint in PETG or ABS.