230 mm Power Strip Holder for 35 mm Timber
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Full-length, support-free holder for a 230 × 53 × 42 mm power strip, designed to screw onto 35 mm structural timber.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
A full-length wall holder for mounting a three-outlet power strip to a 35 mm-wide KVH timber. The strip slides into the open C-channel, while two front retaining wedges and a lower stop keep it securely supported.
Dimensions and fit
- Overall printed size: 62.6 × 230 × 47.8 mm
- Designed power-strip body: 53 mm wide × 42 mm deep × 230 mm long
- Sliding clearance: 0.8 mm per side
- Two 4.5 mm screw holes on 170 mm centres
- 9.2 mm head recesses, 2.8 mm deep
- 16 mm cable notch in the lower stop
Power strips vary in profile even when their nominal length is similar. Measure the actual strip body before printing; the included parametric OpenSCAD source exposes the strip dimensions and clearance near the top of the file.
Printing and installation
- Print in the supplied orientation with the flat back plate on the bed and the channel opening upward.
- Designed for a 0.4 mm nozzle and support-free FDM printing.
- The 230 mm length fits a Bambu Lab P1P build plate with useful clearance from the 256 mm limit. Check placement and exclusion zones in your slicer.
- Choose filament and mounting screws appropriate for the load and ambient temperature. Do not modify the electrical power strip itself.
The geometry and exported mesh have been checked digitally. Fit, material strength and installation have not been verified by a physical test print.
Parametric source
Regenerate this production STL from the included source with OpenSCAD:
openscad -D 'clip_length=230' -D 'bottom_stop=true' \
-D 'screw_spacing=170' -o kvh_35mm_powerstrip_full_230.stl \
kvh_35mm_powerstrip_clip.scad